AT&T Synapse Instalační příručka stáhnout pdf (Strana 43)

Synapse Installation Guide Back to Contents

Installation 42

Without a PC:

If the Deskset has a dedicated network connection, then connect the Deskset to the

network connection only.

1. Plug a Cat.-5 Ethernet cable into the Network port on the back of the Deskset.

2. Plug the other end into the Ethernet wall jack.

To connect power:

[020/031] If you are using PoE, connecting the Deskset to the network also connects

the power.

If you are using the supplied power adapter:

1. Plug the power adapter (blue tag) into the DC Power jack on the back of the Deskset.

2. Plug the power adapter into an outlet not controlled by a wall switch. The display

screen illuminates within about a minute.

If the user's computer is plugged into an uninterruptible power supply (UPS), consider

plugging the Deskset into it, too.

To install the Deskset on a wall:

1. Plug the Ethernet cable into the port on the back of the Deskset. (See “To connect

the Cat.-5 LAN cable to the Deskset:” on page 41.)

2. Plug the power adapter into the jack on the back of the Deskset. Skip this step if

using POE. (See “To connect power:” on page 42.)

3. Place the Deskset base over the mounting plate above the mounting studs as shown

in .

4. Slide the Deskset base down as shown in .

Power Jack

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 167 168

Žádné komentáře

AT&T Synapse Instalační příručka Strana 43