AT&T Synapse Instalační příručka stáhnout pdf (Strana 33)

Synapse Installation Guide Back to Contents

Installation 32

6. Insert a top mounting screw (not included) in one side and turn it several turns to

establish support. Repeat for the other side.

7. Tighten the screws.

Wall Mounting

You can mount the Gateway or ATA to a wall using the two mounting slots on the bottom

of the device. Ensure that the device is oriented as shown in Figure 11 to allow air to

flow vertically through the ventilation holes on each side of the device.

Figure 11. Wall Mount Orientation

To mount the Gateway or ATA to a wall:

1. Install two pan-head screws (with ¼-inch diameter head) 7 ⅞ inches (20 cm) apart.

The screw shaft diameter should be ⅛-inch (3.2 mm). Ensure you use anchors

appropriate for your mounting surface. Leave about ⅛-inch (3.2 mm) clearance

between the screw head and the wall.

2. Position the device with the mounting slot centers aligned over the mounting screws.

Carefully bring the device down onto the screws.

3. Slide the device downwards so that the screws go into the mounting slots on the

device. Ensure the device is secure.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 167 168

Žádné komentáře

AT&T Synapse Instalační příručka Strana 33