
Synapse Installation Guide Back to Contents
Installation 28
Assigning Telephone Lines and Extensions
This section discusses various telephone line configuration issues to consider.
Providing Limited Telephone Service During AC Power Outages
PSTN Gateway
The fourth line on each PSTN Gateway is a Bypass port that works during AC power
failures. If you have a PSTN line plugged into LINE 4, connect a line-powered analog
telephone to the RJ-11 jack labeled BYPASS for telephone service during power failures.
When power returns, a relay disconnects this emergency bypass line so that the bypass
line cannot be used to eavesdrop on normal calls.
If your telephone lines are part of a hunt group (a telephone company feature that allows
calls to a busy phone number to roll over to the next available telephone line), connect
the line with your main (pilot) telephone number to PSTN Gateway LINE 4.
If your system features both PSTN Gateways and a T1 Gateway, outbound calls are
placed first through the T1 channels by default.
T1 Gateway and SIP Gateway
The T1 Gateway and SIP Gateway provide no analog bypass port. To provide telephone
communication during power outages, either subscribe to at least one analog phone line
and install a PSTN Gateway or use uninterruptible power supplies to provide power to
your computer network, the Synapse T1 Gateway or SIP Gateway, and one or more
system Desksets.
Analog Line Connection Order on PSTN Gateways
For outgoing calls, the system first seizes the lowest idle PSTN port numbers (as labeled
on the PSTN Gateway). PSTN phone lines should be connected to your system with your
busiest incoming line placed in the highest port number on the highest numbered PSTN
Gateway, so that incoming calls are less likely to receive busy signals. For instance, if
your customer service team receives many calls, you would want to plug their phone
lines into higher-numbered PSTN ports.
Komentáře k této Příručce