AT&T Telephone R1V2 Uživatelský manuál Strana 117

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 156
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 116
1 At Action = , enter 1.
Reassign an RS232
connector function
2
At Data = , enter the function you want to assign to the
Target connector from the following list:
0 - None (disconnect function)
1 - Admin. (Target 1 or 4 only)
2 - SMDR (Target 2 or 3 only)
3 - Tape (Target 3 only)
4 - Reserved
See footnote* on previous page for default function.
Change length of
Note Unless you’re already administering the Target
RETURN Delay
connector for which you wish to change the RETURN delay,
you must first select a Target connector (by entering t or T
and then entering the appropriate number at the “RS232=”
prompt).
1 At
Action = , enter 2.
2 At
Data = , enter a number from 0 through 2.
The default is 0.
Change Baud Rate Note Unless you are already administering the Target
connector for which you wish to change the Baud Rate, you
must first select a Target connector (by entering t or T and
then entering the appropriate number at the “RS232=”
prompt).
1 At
Action = , enter 3.
2 At
Data = , enter 300, 1200, 4800, or 9600.
See footnote* on previous page for the default data.
15-2 Administering RS232 Parameters
Zobrazit stránku 116
1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 155 156

Komentáře k této Příručce

Žádné komentáře