AT&T Definity 6416D+M Uživatelský manuál stáhnout pdf (Strana 3)

---------- The 100A Analog Interface Module Option Switches ----------

On the bottom of the installed 100A module, there are two option switches, shown at the right.

1. SET THE OPTION SWITCH ON THE LEFT TO EITHER OR .

— When the Option switch on the left is set to 1, the telephone and the Analog adjunct share

the same line. Therefore, only one device, the telephone handset OR the telephone built-in

speakerphone OR the Analog adjunct can transmit on the same line at one time.

If the telephone is connected to a DEFINITY switch prior to Release 8.1, you MUST use Setting 1; that is, you

CANNOT use Setting 2.

— When the Option switch on the left is set to 2, you can use a second line for transmission on the analog adjunct, a

line that is independent of the telephone. When the second line is used, the telephone and the analog adjunct can

use independent lines simultaneously.

If the 100A module is installed on a 6416D+M or 6424D+M telephone connected to a DEFINITY switch Release 8.1

or later, you can set the switch on the left to Setting 1 or 2.

2. IF THE OPTION SWITCH ON THE LEFT IS SET TO , YOU MUST SET THE OPTION SWITCH ON THE RIGHT

TO EITHER

The switch on the right allows you to choose whether the analog adjunct, when active, will be interrupted when you

pick up the handset or turn on the built-in speakerphone. Set the option switch on the right according to the analog

device that is connected with the telephone.

— The option means that the analog adjunct will be interrupted. Use this option for adjunct speakerphones or

answering machines or an analog telephone. If an attached speakerphone does not recognize a far end

disconnect signal, you may have to manually turn off the speakerphone.

—The

FAX option does not interrupt the analog adjunct. This option is useful for fax machines and modems.

Connect the analog adjunct such as a modem,

fax machine, or analog telephone to the

module.

The desktop stand has slots in which you can

store the cover ( ) you removed from the

module opening (see Step 2) in case you need

to reinsert the cover at a later time.

( shows the location of the storage area.)

Snap the tabs on the cover into the slots

provided on the desktop stand.

FAX

1 2 3 4 5 6

Žádné komentáře

AT&T Definity 6416D+M Uživatelský manuál Strana 3